Sandisk CompactFlash Extreme III User Manual Page 38

  • Download
  • Add to my manuals
  • Print
  • Page
    / 108
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 37
Interface Description SanDisk CompactFlash Card OEM Product Manual
The PIO data transfer parameters are defined in Table 3-16.
NOTE: SanDisk CompactFlash Memory cards do not assert an -IORDY
signal.
Table 3-16 PIO Data Transfer to/from Device
PIO Timing Parameters
Mode 0
(ns)
Mode 1
(ns)
Mode 2
(ns)
Mode 3
(ns)
Mode 4
(ns)
t
0
a
Cycle time (min.) 600 383 240 180 120
t
1
Address valid to IORD-/IOWR- setup
(min.)
70 50 30 30 25
t
2
a
IORD-/IOWR- pulse width 16-bit (min.) 165 125 100 80 70
t
2ia
IORD-/IOWR- recovery time (min.) --- --- --- 70 25
t
3
IOWR- data setup (min.) 60 45 30 30 20
t
4
IOWR- data hold (min.) 30 20 15 10 10
t
5
IORD- data setup (min.) 50 35 20 20 20
t
6
IORD- data hold (min.) 5 5 5 5 5
t
6z
b
IORD- data tri-state (max.) 30 30 30 30 30
t
9
IORD-/IOWR- to address valid hold
(min.)
20 15 10 10 10
a. t
0
is the minimum total cycle time, t
2
is the minimum command active time, and t
2i
is the minimum
command recovery time or command inactive time. The actual cycle time equals the sum of the
actual command active time and the actual command inactive time. The three timing requirements of
t
0
, t
2
, and t
2i
shall be met. The minimum total cycle time requirements are greater than the sum of t
2
and t
2i
. This means a host implementation may lengthen either or both t
2
or t
2i
to ensure that t
0
is
equal to or greater than the value reported in the devices IDENTIFY DEVICE data. A device imple-
mentation shall support any legal host implementation.
b. This parameter specifies the time from the negation edge of /IORD to the time that the data bus is no
longer driven by the device (tri-state).
3.4 Card Configuration
SanDisk CompactFlash Memory cards are identified by appropriate information in the Card
Information Structure (CIS). The configuration registers are used to coordinate the I/O spaces
and the interrupt level of cards that are located in the system.
02/07, Rev. 12.0 3-20 © 2007 SanDisk Corporation
Page view 37
1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 107 108

Comments to this Manuals

No comments